What is Waterproofing A Basement All About?

The basement waterproofing systems and their working.

 For answering that question it will help to first take a look at historically conventional basement waterproofing and the way it was supposed to work.

In case you are curious to know how the basement is built, you will see that the idea was first conceived in the design and then the next steps follow. It starts with the digging of a big hole, then the footer or foundations are laid. After the base is done, the walls of the basement are built and then only the rest of the house is constructed.

 That big hole in the ground, the first on the list above is important to note.

 When the walls of the basement are built, there is always a gap left outside the walls which needs to be filled. Loose backfill is used to fill in the gap. The problem here is that water looks for the path of least resistance, and you’ve just given it just that with a huge pile of loose backfill, no matter how well it’s been compacted.

This area is going to have water constantly seeping into it. Sometimes, creating a problem is the drainpipe that gets full of silt contained in many systems when waterproofing a basement. As the water comes it brings all sorts of suspension with it and that is to be expected as it is natural. Allowing these pipes to fill up, can result in an overload of the system, which can be catastrophic to the basement’s outside walls. If there are crevices in the walls, water will push through even if the basement walls are waterproofed.

 The problem of this type is not easily rectified. The reason is that the pipes which are supposed to take away the excess water are gradually getting deteriorated and worsen over time.

 A huge problem is that often there isn’t access to these pipes. In an attempt to keep excess moisture out basement waterproofing also can be put onto the outer walls of the basement. Usually this is called a tanked system.

If you want to find out if you have water inside the concrete block of your walls simply tap a hole into the concrete block, near the floor, and see if you have water coming out of this block then you may want to consider a drained cavity waterproofing system this system drains the water from your walls, much the same way you just did, by adding drain holes in the bottom blocks that allows those areas to drain into a type of interior french drain system. To move water away from your property; it first must be collected and sent through drainage channels to a sump pump or a natural drainage field.

Waterproofing a basement is when they are installed internally, have easy access ports for removing silt, and can be installed in basements where other methods have failed.

So to summarise, a good basement waterproofing system will:

 - usually be a permanent or long-term solution
 - stop both ways by which water can enter through the walls and up from the floor
- not disturb landscaping, decks, patios, driveways, etc
- usually be an approved waterproofing method for home loans
- often be substantially cheaper than other waterproofing methods

You want to be sure to choose a reliable waterproofer for your home, keep in mind that it will greatly increase the value by far more than what you initally paid.

In conclusion, you want a basement waterproofing system that will deliver:

 - a permanent or long term fix
- stop water through the floor and walls
- not disturb the exterior appearance of your home
- an approved method by home loan lenders
- more affordable than other methods

You should look at waterproofing not as an expense but as an investment in the value of your home.